Experimental incubator - news

From Food Hacking Base
Revision as of 13:41, 19 January 2014 by Algoldor (talk | contribs) (Created page with "At the moment the most up to date info is at the top of the page, have fun! ===='''Code uploaded to Github''' 19/1/2014==== Here is the link to the code which is now uploa...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

At the moment the most up to date info is at the top of the page, have fun!


Code uploaded to Github 19/1/2014

Here is the link to the code which is now uploaded to the Github


https://github.com/foodhackingbase/incubator


thanks to Lars and others from WarpZone for sharing and of course Arnd for the coding.

At the moment the code allows to measure temperature directly after switching on the Arduino, nice and simple. Not sure what else it is ready to do. Next step should be setting up switching the peltier heater on through relay, 39-43C would be fine.


What pins belong to what (before 19/1/2014)

Here is just a link to the info which Arnd made in preparation for 30c3, you can clearly see what pins are doing what

http://wiki.techinc.nl/index.php/Fermentation_controller#An_overview_of_pins_used

Under Arnd's supervision I was able to do all the necessary soldering by myself, putting together therefore one functional prototype, testing it later - it was doable.

An overview of pins 

    D0: Serial RX
   D1: Serial TX
   D2: SSR1
   D3: SSR2
   D4: LCD D4
   D5: LCD D5
   D6: LCD D6
   D7: LCD D7
   D8: LCD RS
   D9: LCD 'Enable' (might be optional)
   D10: LCD backlight control (might be made optional)
   D11: One-wire bus 1 (first temp-probe)
   D12: One-wire bus 2 (second temp-probe)
   D13: Free (see note below about LCD and buttons) 

   A0: LCD Buttons
   A1: Free
   A2: Free
   A3: Free
   A4: I2C SDA-line for DS1307
   A5: I2C SCL-line for DS1307
Retrieved from "https://foodhackingbase.org/index.php?title=Experimental_incubator_-_news&oldid=41"