Experimental Incubator/history

From Food Hacking Base
Revision as of 10:37, 29 October 2013 by Algoldor (talk | contribs) (Created page with "Here you can find an overview of the experimental incubator (ei) project past, enjoy the read. 2010 - beginning. The experimental incubator was first discussed and tempered w...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Here you can find an overview of the experimental incubator (ei) project past, enjoy the read.

2010 - beginning. The experimental incubator was first discussed and tempered with at Noisebridge around 2010 in the group which focused on food and beverage hacking, especially fermentations. We did not get too far but still we have done some experimenting with Arduino, calibrating the temperature probes (thermistors) and measuring temperature with them, transferring the data to the computer. The brain as mentioned was Arduino micro controller, all work done under the Linux. In this time Mario, Benie, Fabian, Mike, Glen and Algoldor were involved mostly.

2011 - winter - during the visit of ChaosKueste on invitation of Sven, the crew there build for me a simple control element which allowed me to switch on and off the heating element through Arduino based on the temperature sensor and reading, the code got unfortunately lost and device broken during the travels. However it was the first functioning control element to my memory in my holding (Algoldor).

2011 -

2012 - during my visit of C-Base I have met Mic, who engineered and programmed for me a control element based again on Arduino and this time printed circuit board (pcb). code can be found here.

Experimental incubator c base 800 2012.jpg

Experimental incubator c base test 800 2012.jpg